BSP-充电名词解释

充电名词解释

• A~G
• H~N
• O~T
• U~Z

A~G

ACA = accessory charger adapter = 辅助充电适配器
ACC = apparent charge capacity = 表观电荷容量
AICL = automatic input current limiting = 自动输入电流限制
AICR = Average Input Current Regulation = 平均输入电流管控
AMA = Alternate Mode Adapter = 替代模式适配器
AMC = Autonomous mode control = 自动模式控制
AMUX = Analog multiplexer = 模拟多路复用（数据选择）器
AOP = Always on processor
APC = Autonomous phase control = 自动相位控制
APSD = Automatic power source detection =自动电源检测
ATC = Auto-trickle charger = 自动涓流充电器
AVS = adaptive voltage scaling = 自适应电压调节
BAM = Bus access module = 总线存取模块
BCBC=Backlight Correction Base on Content=基于内容的背光校准
BCL = Battery current limit = 电池电流限制
BIF = battery interface = 电池接口
BLSP = BAM Low-Speed Peripheral = 总线存取模块低速外设
BMD = Battery missing detection = 电池丢失检测
BMS = battery monitoring system = 电池监测系统
BSG = Battery Security Guard = 电池安全保护
BSI = Battery serial interface = 电池串行接口
BTM = battery temperature monitor = 电池温度监控
BTS = board thermal sensor = 主板温度传感器
CABC = content adaptive backlight control =内容自适应背光控制
CC = Configuration Channel = 配置通道
CDMA = 码分多址
CDP = Charging downstream port = 充电下行端口
CP=Charging port=充电端口
DCP = Dedicated charging port = 专用充电端口
DFP = Downstream-Facing Port = 下行端口（Host端）
DPM = Dymanic Power Management = 动态电源管理
DRP = Dual-Role Port = 双角色端口
DOD = depth of discharge = 电池放电量与电池额定容量的百分比（超过80%即可视为深度放电）
DTS = Device Tree Source
DTSI = Device Tree Source Include
DVS = Dynamic voltage scaling = 动态电压调节
EMCA = Electronically Marked Cable Assembly = 封装有E-Marker芯片的Type-C有源电缆
EOC = End of charge = 充电终止
= End of Conversion = 转换结束
ERM = eccentric rotating mass =偏心旋转质量
ESR = Equivalent series resistance = 等效串联电阻
FCC = Full charge capacity = 满电容量
FFBM = Fast Factory Boot Mode = 快速工程启动模式
GSM = global system for mobile communications = 全球移动通信系统

H~N

HDD = Hard Disk Drives = 硬盘驱动器
Hi-Z = High-impedance = 高阻态
HK = housekeeping = 内务管理
HLOS = High Level Operating system = 高级操作系统
HPM = High power mode = 高功耗模式
IBB = Inverting buck/boost converter = 反向降压/升压变换器
I2C = inter-integrated circuit = 内部集成电路
INOV = intelligent negotiation of optimal voltage = 最优电压智能协商
IPA = IP packet accelerator = IP包加速器，硬件处理模块
JEITA = Japan Electronics and Information Technology Association = 日本电子与信息技术产业协会
LDO = low dropout（linear regulator） = 低压差线性稳压器
LPM = Low power mode = 低功耗模式
LRA = linear resonant actuators = 线性谐振致动器
LSB = Least Significant Bit = 最低有效位
MIPI = Mobile Industry Processor Interface = 移动产业处理器接口
MIVR = Minimum Input Voltage Regulation = 最小输入电压管控
MPM = Normal – Medium power mode = 正常中等功耗模式
MPP = Multipurpose pin = 复用引脚
MSB = Most Significant Bit = 最高有效位
NCP = negative charge pump = 负电荷泵
NTC = Negative Temperature Coefficient = 负温度系数

O~T

OCP = over current protection = 过流保护
OCV = open circuit voltage = 开路电压
OTG = On-the-go
OTP = One-time programmable = 一次性可编程的
OVLO = over voltage lock out = 过压锁保护
OVP = overvoltage protection = 过压保护
PBS = Programmable boot sequence = 可编程启动时序
PDO = Power Data Object = 表示SRC端供电能力或SNK端受电需求的电源等级
PFM = pulse frequency modulation = 脉冲频率调制
PDM = pulse density modulation = 脉冲密度调制
PDN = power delivery network = 电源传输网络
PSRR = power supply rejection ratio = 电源抑制比
PWM = pulse width modulation = 脉宽调制
QFE = Qualcomm Front-end = 高通前端
QTI = Qualcomm Technologies, Inc = 高通技术公司
QUP = Qualcomm Universal Peripheral = 高通通用外设
RCO = RC oscillator = 电阻电容型振荡器
RPM = Resource power manager
RSC = Resource state coordinator = 资源状态协调器
RT = real-time = 实时
SBL = secondary boot loader = 次级引导程序
SCHG = Switched-mode battery charger/boost = 开关模式电池升压充电器
SDP = Standard downstream port（USB） = 标准下行端口
SMB = switch mode battery charger = 开关电池充电器
SMPL = sudden momentary power loss = 突然性瞬时电源缺失
SMPS = switch mode power supply = 开关电源
SODI = Screen On Deep Idle = 亮屏深度空闲状态
SPMI = system power management interface = 系统电源管理接口
SPMI = Serial power management interface = 串行电源管理接口
TA = travel adaptor = 便携式充电适配器
TLMM = Top-level mode multiplexer = 顶层模式多路复用

U~Z

UFP = Upstream-Facing Port = 上行端口（device端）
USB = Universal serial bus = 通用串行总线
UEFI = unified extensible firmware interface = 统一可扩展固件接口
UVLO = Under Voltage Latch-Out = 欠压（电压过低）锁保护
VBATT = Voltage Battery = 电池电压
WFI = Wait for interrupt = 等待中断状态（休眠状态）
XO = crystal oscillator = 晶体振荡器
XOB = crystal oscillator buffer = 晶体振荡器缓冲区
ZCV = Zero current voltage = 零电流电池电压（电压的理想测量状态即零电流）