Arduino重置-复位问题

转自： https://blog.csdn.net/y511374875/article/details/77845240

三种方式手动重启Arduino

1.Arduino板上重新编写代码时，Arduino将重新设置 2.Arduino软件中打开串行终端，同时将Arduino板连接到计算机。打开串行终端时，Arduino会自动重置 3.按下复位按钮

两种方式自动重启Arduino

详情见： https://www.theengineeringprojects.com/2015/10/upload-bootloader-atmega328.html

1.使用Arduino板上的RESET引脚以编程方式重新设置Arduino，就是利用一个数字口，代码运行到那的时候就将REST置低 这里利用数字口D2

int Reset = 2;

void setup() {    digitalWrite(Reset, HIGH);   delay(200);   pinMode(Reset, OUTPUT);       Serial.begin(9600);   Serial.println("How to Reset Arduino Programmatically");   delay(200); }

void loop() {   Serial.println("A");   delay(1000);                 Serial.println("B");   delay(1000);                 Serial.println("Now we are Resetting Arduino Programmatically");   Serial.println();   delay(1000);   digitalWrite(Reset, LOW);   Serial.println("Arduino will never reach there.");

}1234567891011121314151617181920212223

2.不使用任何硬件引脚，Arduino有一个名为resetFunc（）的内置函数，我们声明函数地址为0，当我们执行此功能时，Arduino将自动重置。

说明： –In this method, we are not gonna use any hardware pin, instead we will do everything in programming. –Arduino has a builtin function named as resetFunc() which we need to declare at address 0 and when we execute this function Arduino gets reset automatically. –So, no need of doing anything in hardware and simply upload the below code in your Arduino board.

void(* resetFunc) (void) = 0;

void setup() {       Serial.begin(9600);   Serial.println("How to Reset Arduino Programmatically");   delay(200); }

void loop() {   Serial.println("A");   delay(1000);                 Serial.println("B");   delay(1000);                 Serial.println("Now we are Resetting Arduino Programmatically");   Serial.println();   delay(1000);   resetFunc();   Serial.println("Arrduino will never reach there.");

} --------------------- 作者：y511374875 来源：CSDN 原文：https://blog.csdn.net/y511374875/article/details/77845240 版权声明：本文为博主原创文章，转载请附上博文链接！