LVS 负载均衡——直接路由模式DR

一、配置的网络拓扑结构图

二、配置lvs服务器

• 配置虚拟网卡地址（VIP地址）

[root@localhost ~]# ifconfig eno16777728: 192.168.200.253 netmask 255.255.255.0
#查看配置结果
[root@localhost ~]# ifconfig eno16777728:
eno16777728:: flags=<UP,BROADCAST,RUNNING,MULTICAST>  mtu
        inet 192.168.200.253  netmask 255.255.255.0  broadcast 192.168.200.255
        ether :0c::f0::  txqueuelen   (Ethernet)

• 安装ipvsadm软件包实现lvs轮询

[root@localhost ~]# yum -y install ipvsadm
#查看安装结果
[root@localhost ~]# rpm -qa ipvsadm
ipvsadm-1.27-.el7.x86_64

• 配置轮询规则

[root@localhost ~]#  ipvsadm -A -t 192.168.200.253: -s rr
[root@localhost ~]#  ipvsadm -a -t  192.168.200.254: -r 192.168.200.112: -g -w
[root@localhost ~]#  ipvsadm -a -t  192.168.200.253: -r 192.168.200.113: -g -w 

三、配置Apache节点服务器（两台服务器配置相同）

• 配置虚拟网卡IP地址（VIP地址）

[root@localhost ~]# ifconfig lo:  192.168.200.253 netmask 255.255.255.255 

• 添加路由规则

[root@localhost ~]# route add -host 192.168.200.253 dev lo:
#将访问VIP的数据限制在本地以避免通信紊乱。

• 调整/proc响应参数

[root@localhost ~]# vim /etc/sysctl.conf
net.ipv4.conf.all.arp_ignore=
net.ipv4.conf.all.arp_announce =
net.ipv4.conf.default.arp_ignore =
net.ipv4.conf.default.arp_announce =
net.ipv4.conf.lo.arp_ignore =
net.ipv4.conf.lo.arp_announce =
#启用参数
[root@localhost ~]# sysctl -p
net.ipv4.conf.all.arp_ignore =
net.ipv4.conf.all.arp_announce =
net.ipv4.conf.default.arp_ignore =
net.ipv4.conf.default.arp_announce =
net.ipv4.conf.lo.arp_ignore =
net.ipv4.conf.lo.arp_announce = 

• 安装Apache开启服务

[root@localhost ~]# yum -y install httpd
#开启httpd服务
[root@localhost ~]# systemctl start httpd

四、测试

• 所有机器关闭防火墙，安全规则

[root@localhost ~]# systemctl stop firewalld
[root@localhost ~]# setenforce
[root@localhost ~]# iptables -F

• 准备测试页

[root@localhost ~]# echo "" > /var/www/html/index.html

• 测试