MSP430F5438A的串口

设置串口，最关键的是波特率的设置，推荐一个网站，很方便地计算波特率，http://software-dl.ti.com/msp430/msp430_public_sw/mcu/msp430/MSP430BaudRateConverter/index.html

 P3SEL |= (BIT4 + BIT5);                      // P3.4,5 = USCI_A0 TXD/RXD
   UCA0CTL1 |= UCSWRST;                      // **Put state machine in reset**
   UCA0CTL1 |= UCSSEL_2;                     // CLK = SMCLK
   UCA0BR0 = ;                           // 24MHz/57600=26,1,0,1
   UCA0BR1 = ;                           //
   UCA0MCTL = UCBRF_1+UCBRS_0+UCOS16;        // Modulation UCBRSx=0, UCBRFx=0,UCOS16 = 1
   UCA0CTL1 &= ~UCSWRST;                     // **Initialize USCI state machine**
   UCA0IE |= UCRXIE;                         // Enable USCI_A0 RX interrupt

#pragma vector=USCI_A0_VECTOR
__interrupt void USCI_A0_ISR(void)
{
  switch(__even_in_range(UCA0IV,))
  {
  case :break;
  case :break;
  case :break;
  default:break;
  }
}

关键就是UCA0IV 寄存器，通过看文档得知，这是 USCI_Ax Interrupt Vector Register，具体功能如下：

00h = No interrupt pending，0是无中断
02h = Interrupt Source: Data received; Interrupt Flag: UCRXIFG; Interrupt
Priority: Highest，2是数据接收触发中断
04h = Interrupt Source: Transmit buffer empty; Interrupt Flag: UCTXIFG;
Interrupt Priority: Lowest，4是数据发送中断

经常使用的是接收中断，没用过发送中断