RS232

RS232的最大的传输速率大约10KBytes/s。

全双工工作方式，异步。数据是8位作为一块来发送的，先发送最低位，最后发送最高位。

在232通信中：

1. Both side of the cable agree in advance on the communication parameters (speed, format...). That's done manually before communication starts.
2. The transmitter sends "idle" (="1") when and as long as the line is idle.
3. The transmitter sends "start" (="0") before each byte transmitted, so that the receiver can figure out that a byte is coming.
4. The 8 bits of the byte data are sent.
5. The transmitter sends "stop" (="1") after each byte.

通信中有关时钟速率能不能设置成任意速率的问题，答案是不能，只能设置特定的速率。

• 1200 bauds.
• 9600 bauds.
• 38400 bauds.
• 115200 bauds (usually the fastest you can go).

At 115200 bauds, each bit lasts
(1/115200) = 8.7µs. If you transmit 8-bits data, that lasts 8 x 8.7µs = 69µs. But each byte requires an extra start and stop bit, so you actually need10 x 8.7µs = 87µs. That translates
to a maximum speed of 11.5KBytes per second.

At 115200 bauds, some PCs with buggy chips require a "long" stop bit (1.5 or 2 bits long...) which make the maximum speed drop to around 10.5KBytes per second.

就是说在115300的波特率下，有的电脑最大的速度可能是11.5KBytes/s或者10.5KBytes/s.

电压所代表的值：

• "1" is sent using -10V (or between -5V and -15V).
• "0" is sent using +10V (or between 5V and 15V).

为了最容易的产生波特率1.8432Mhz的晶振是个好的选择，当除以16就是115200hz。

有关波特率的计算方法：

假如，手上的板子上晶振2M，想要115200的波特率，那在FPGA上的实现方法是先计算出tick多少次，2000000/115200次，这个式子表示的就是分频多少次（从2M变成115200要进行多少分频，就是原先的时钟变换多少次，现在的始终才变换一次）。然后简化出1024/59次，出现1024后较方便实现。

reg [10:0] acc;   // 11 bits total!



always @(posedge clk)

  acc <= acc[9:0] + 59; // use only 10 bits from the previous result, but save the full 11 bits



wire BaudTick = acc[10]; // so that the 11th bit is the carry-out

在用上位机打开串口的时候，发送端会有1.5s的低电平，然后恢复成高电平。

版权声明：本文为博主原创文章，未经博主允许不得转载。