rk3288 LED上加入heartbeat功能

平台：瑞芯的rk3288

作者：fulinux

*****本文同意转载。只是请注明出处：http://blog.csdn.net/fulinus****

1、硬件环境

随意选取一个GPIO引脚作为heartbeat的输出。选择一个未被使用的SPI0_CSn0，如底板原理图所看到的：

watermark/2/text/aHR0cDovL2Jsb2cuY3Nkbi5uZXQvZnVsaW51cw==/font/5a6L5L2T/fontsize/400/fill/I0JBQkFCMA==/dissolve/70/gravity/Center" alt="" />

相应在顶板上连接rk3288的是GPIO5 _ B5 _ u引脚，如图：

2、软件环境

在kernel/arch/arm/boot/dts/rk3288-tb_8846.dts文件里配置例如以下：

diff --git a/arch/arm/boot/dts/rk3288-tb_8846.dts b/arch/arm/boot/dts/rk3288-tb_8846.dts
index c92d973..91ad1da 100644
--- a/arch/arm/boot/dts/rk3288-tb_8846.dts
+++ b/arch/arm/boot/dts/rk3288-tb_8846.dts
@@ -6,6 +6,16 @@
 #include "vtl_ts_sdk8846.dtsi"

 / {
+    leds {
+        compatible = "gpio-leds";
+        led0 {
+            label = "led0";
+            gpios = <&gpio5 GPIO_B5 GPIO_ACTIVE_HIGH>;
+            linux,default-trigger = "heartbeat";
+            default-state = "off";
+        };
+    };
+
        fiq-debugger {
                status = "okay";
        };

内核配置例如以下：

--- LED Support

<*>   LED Support for GPIO connected LEDs

[*]   LED Trigger support  ---> 

<*>   LED Heartbeat Trigger

正常编译后烧录到开发板上，通过示波器能够看到心跳波形：

watermark/2/text/aHR0cDovL2Jsb2cuY3Nkbi5uZXQvZnVsaW51cw==/font/5a6L5L2T/fontsize/400/fill/I0JBQkFCMA==/dissolve/70/gravity/Center" alt="" />